favorite
favorite
hide
unhide
flag

Posted

print

Detroit s60 14.0L fully rebuilt - $32,000 (Lynden)

Detroit s60 14.0L fully rebuilt 1 thumbnailDetroit s60 14.0L fully rebuilt 2 thumbnailDetroit s60 14.0L fully rebuilt 3 thumbnailDetroit s60 14.0L fully rebuilt 4 thumbnailDetroit s60 14.0L fully rebuilt 5 thumbnail
condition: like new
make / manufacturer: Detroit
model name / number: S60 14L
Engine is located approx. 2 miles from Canadian border.

Detroit Diesel Series 60 14L

ESN: 06R0768104

This is a rebuilt Detroit S60 14L.

Engine block fully machined, deck resurfaced, counter bores reworked, liner retaining bores sleeved and rebored.

Crankshaft machined, polished and balance checked.

All connecting rods reconditioned and wrist pin bushings replaced.

New piston oil squirters replaced along with new bolts (Detroit component).

Main bearings, rod bearings, and thrust washers replaced (Interstate-Mcbee components).

Main bearing and rod bearing clearances checked along with crankshaft backlash. All new pistons, wrist pins and liners and seals replaced (Detroit components).

Liner heights were checked.

New Detroit oil pan.

All head bolts and washers are new (Detroit components).

(6) new reman Detroit injectors.

The cylinder head was surfaced and fully reconditioned with new valves, seals, seats cut, and installed with new head gasket and cam plate seals.

New cam bearings installed (Detroit component).

Camshaft lightly polished. All rocker assemblies fully disassembled and inspected and measured and any components replaced as needed.

All jake brake assemblies were fully disassembled, inspected and rebuilt with new internal hardware.

New oil cooler and seals installed (Detroit components).

Detroit reman turbo installed. Exhaust manifold surfaced and gaskets replaced.

New Detroit accessory drive installed.

New Detroit water pump installed.

Rocker box and valve cover seals replaced. All external components installed to engine block received new seals or gaskets.

New front and rear main seals.

New injector and jake harness.


All internal components are heavily coated with oil or assembled with assembly lube as well as a low pressure prime to fill internal oil galley.


More pictures available upon request.

post id: 7756383589

posted:

best of [?]

loading
reading
writing
saving
searching